1911 Punisher Grips ? Black Rosewood with Carved Dragon Scales and Skull Medallion, Full Size

Black rosewood panels carved with overlapping dragon scales and finished with a matte black skull medallion seated flush into the wood. Most 1911 Punisher grips on the market are stamped polymer or printed rubber, these are the carved-wood version. Same recognizable skull, real materials, built to last decades on a serious 1911 build. Made for veterans, EDC carriers, and shooters who want the Punisher look without the tacticool plastic. Engineered as a true bolt-on upgrade. Pull your factory panels, set these in place, and tighten your existing grip screws. No sanding, no shimming, no gunsmith. Sized for full-size single-stack 1911s with the standard 3-1/16″ screw spacing, Colt Government, Colt Commander, and Government-spec clones from Kimber, Springfield, Ruger SR1911, S&W SW1911, Remington R1, Sig 1911, Rock Island, GSG, and Taurus. Cut for ambidextrous safeties. Will not seat on Officer/compact frames, 2011 double-stacks, or magwell-cut competition builds. Black rosewood earns its place here because it’s one of the hardest, most stable grip woods available, denser than standard rosewood, less prone to warping than walnut. The dark grain holds the dragon scale carving cleanly and gives the matte skull medallion a backdrop that doesn’t compete with the design. The medallion is inlaid, not surface-glued, so it stays flush through years of solvents, oils, and range trips. Cut, carved, and finished in North Carolina. Over 50,000 1911 grips shipped to American shooters. 30-day returns if the fit isn’t right or panels arrive damaged.